Fleece Performance Freedom Street Series Long Block - 2013-2018 Cummins 6.7L

Product Name: Fleece Performance Freedom Street Series Long Block - 2013-2018 Cummins 6.7L 
Manufacturer: Fleece 
Manufacturer Part #: FPE-CUMM-67L-LB
Thoroughbred Diesel Part #: FPE-CUMM-67L-LB 
Fitment Notes: 2013-2018 Dodge Cummins 6.7L

Fleece Freedom Street Series is perfect for a daily driver or towing application. Machined and assembled in our state-of-the-art Freedom Racing Engine shop, our engines are remanufactured with the critical upgrades to the common problem areas. Fully blueprinted with all clearances exceeding factory specifications, our Street Series engine will get you back on the road faster. 

INSTALLATION NOTES

The long block is shipped with the following gaskets and seals:

• Camshaft seal
• Water pump seal
• Crankcase drain gasket
• Coolant inlet, A/C compressor bracket O-ring
• Fuel banjo washers
• CP3 nut access cover gasket
• CP3 snout O-ring
• Additional sensor O-rings

FINAL TESTED

To ensure the highest quality, all long blocks are run on a fully automated engine test stand after assembly.  This testing includes:

• Vacuum testing of the entire coolant system.
• Pre-torque test to pre-lube and verify oil flow to all components.
• Torque test and measurement of crankshaft loads.
• Run-in test to verify oil pressure and flow.
• Compression test on all cylinders. 

Fleece recommends the following new valvetrain components to accompany our long blocks:

• Rocker Arm Assemblies (FPE-CUMM-RAA-CR)
• Pushrods (FPE-CUMM-S2-PROD)
• Billet Rocker Arm Bridges (FPE-BRAB-C1)

* Proper valve lashing is required. Back off adjusters on rocker arms during installation or damage will occur to the cylinder head and/or piston to valve contact may occur.

Fleece Performance Freedom Street Series Long Block Features:

• Reconditioned block that is decked, bored, torque plate honed, align honed, pressure tested, and painted black.
• Genuine Cummins rods
• New pistons and rings
• New main bolts and hardened main dowels
• Reconditioned factory crankshaft
• Reconditioned factory camshaft
• New P Series main and rod bearings
• New tappets
• New oil pump
• New oil cooler
• New oil pressure relief valve and regulator spring
• New engine oil pan
• New freeze plugs in all block locations
• New front and rear main seals with wear sleeve
• New lower gasket kits
• New head gasket
• Custom Age 625 head studs
• Freedom Series Street Cylinder Head
• A case of Amsoil break-in oil and Fleetguard filter
• 1 Year Limited Warranty